Wednesday 17 February 2016

Experiment 5(a) : Measurement of Rotational Speed using Electromagnetic pick-up.

Setup:


The setup has two units
  • Signal Conditioning and Processing unit.
  • Sensor Module.

Fig.1 Signal conditioning and processing unit.
  • The signal conditioning board has a variable DC power supply source to change the speed of Motor.
  • It has a 4 digit LED display to show the RPM of motor.
  • There are three test points, one after the wave shaper block, another after the multiplier block and other is for testing 1Hz signal. All the test signals are measured w.r.t ground point.
  • There are five sockets for sensor module interface. Two for motor (red, black) and remaining three for sensor (yellow, blue and green).
  • The sensor module consists of a 12V DC motor, a 15 tooth metallic circular disc connected to the shaft of DC motor and an electromagnetic switch fitted on a clamp near to the slots of the disc.



Working Principle: 

  • When a magnetic material is brought near to the electromagnetic switch, it gives a logic high (5V) at the output. And gives logic low (0V) when there is no magnetic material near to it.
  • When the motor gets supply it rotates along with slotted circular disc.
  • The electromagnetic switch has been fitted close to the slot of the disc.
  • During rotation when a teeth passes the electromagnetic switch it gives a logic high signal and a logic low signal which immediately follows due to the air gap between two slots.
  • So in a complete rotation of the disc the sensor gives 15 pulses.
  • These pulses are feed to the signal conditioning for further processing


Fig.2 Sensor Module

  • In the signal conditioning board, these pulses are immediately passes through a wave shaping circuit to give them a perfect square wave shape. Then they are multiplied by a multiplier circuit by a factor four to show the speed directly in RPM.
  • After multiplication these signals are feed to a frequency counter that counts the pulse for one second and it is then passed to the display unit.
  • There is a toggle switch for the display to show the speed in RPM and the no. of counts. Two push button switches named as reset and push to count are associated for counting purpose. By counting the pulses for particular second we can calculate the speed manually.

Apparatus Required:


  • Multimeter.
  • DSO.
  • Trace sheet or pen drive of 4 GB or less.


Procedure to Experiment:

  • Rotate the power supply knob anticlockwise so that it should reach at the extreme left position.
  • Connect the sensor and motor to their respective socket on the board.
  • Switch ON the power to the board.
  • Make sure that the toggle switch below the display is pointing towards the RPM.
  • Connect a multimeter in 20V DC range at the motor socket on the board.
  • Take a dual trace CRO, connect one channel at the output of wave shaper test point (TP-1) and other channel at the output of multiplier test point (TP-2) w.r.t ground.
  • Rotate the power supply knob slowly in clockwise direction to start the motor to rotate.
  • Note down the supply voltage reading on the multimeter, RPM reading on the display and frequency of both the channel on the CRO screen.
  • Rotate the knob to change the supply voltage and note down all the above parameters again.(continue for 10 readings.
  • Trace or save three to five wave forms. Follow the link how to save wave form in pen drive.

Manually measurement of RPM:

  • Toggle the toggle switch to SPEED.
  • Push the Reset button 2 to 3 times until getting 0000 reading on the display.
  • Start the stopwatch then push and hold the Push to count button.
  • Stop the stop watch after some second say (T), release the push button switch and note down the count on the display say (C).
  • Then RPM = 4C/T

Observation:

Sl no
Supply voltage
Frequency at Wave shaper Output
Frequency at Multiplier output









No comments:

Post a Comment